Owner's manual

R,32532-EN 5/2/01 4:31 PM Page 14
Solution
Check power cord for a secure connection.
Unplug the unit for a moment, and then plug
into power source again.
Check the outlet by plugging in another device.
Increase the volume setting.
Check connection to speakers.
Check that you have selected the appropriate
function: CD, TAPE, Tuner.
Make sure mute is off.
Check antenna connection.
Move antenna.
Turn offnearby electricalappliances,such as
hairdryer,vacuum cleaner,microwave, fluores-
cent lights.
Check that CD is in the tray.
Check that CD label is facing up.
Check that PAUSE mode is not on.
Check that CD function is selected.
Use CD lens cleaner.
Clean the disc.
Clean the disc.
Check disc for warping, scratches, or other
damage.
Solution
Check if something is causing the system to
vibrate. If so, move the system.
Make sure the speakers are at least 3 feet away
or on a different surface from the main unit.
Switch to another function (TAPE, Tuner) and
then back to CD.
Inspect the tape heads and clean and demag-
netize.
Check that the batteries are properly installed.
Replace weak batteries.
Check the system is plugged into power source.
Point the remote directly at the system's front
panel.
Move closer to the system.
Remove any obstacles between the remote and
the system.
Disconnect the audio system from the power source
before performing any maintenance.
Cleaning
Clean the exterior of the systemusing asoft dust
cloth.
CD Player
CAUTION! Thissystemoperates with a laser.It must
be opened by only a qualified technician.
Tape Player
Toprevent deterioration of sound quality, periodical-
icheads, pinch roller, and capstan with a cotton bud
dipped in alcohol. Also, demagnetize the head by
playing a demagnetizing cassette (available through
an audio equipment store).
Zopro,ectrecord,n0,oneoriili!i
both sides of a tape, remove
the corresponding tab. If you ......
later want to record on the tape, affix a piece of
adhesive tape over the hole.
Quit Slacking- A little bit of slackin
iiii!!il
your tapes can causescratcheson
the tape, or worse yet, the tape t_J
could break. If you notice some slack
in the tape, usea pencil to tighten it up before you i
•. ly open the door of each deck and clean the magnet- insert it. ..."
•".................................................................................................................................................................................. ."
1__0