Stereo Receiver with Remote Control owner's manual

9
OPERATION
Warning: To prevent possible hearing loss, turn VOLUME to MIN
before you turn on the receiver or change the program source. After
you turn on the receiver or change the program source, adjust
VOLUME to a comfortable listening level.
You can use the supplied remote control by pointing it at the
receiver’s front panel and pressing the desired button(s). Many
buttons on the remote control work the same as buttons on the
receiver’s front panel. Use these buttons exactly as you would use the
corresponding buttons on the receiver.
1. Press
POWER to turn on the receiver. It takes about 5
seconds to hear sound.
2. Select the speakers. An indicator lights next to the
A and/or B to
show which speakers are on.
If you connected speakers only to the
A (or B) SPEAKERS
terminals, press
SPEAKERS A (or B) to turn on only those
speakers. Do not press both
SPEAKERS A and B because doing
so turns off all speakers even though both indicators are on.
If you connected speakers to both the
A and B SPEAKERS
terminals, you can:
• Press
SPEAKERS A or B to turn on either pair of speakers
for a two-speaker effect.
• Press
SPEAKERS A and B to turn on both pairs of speakers
for a four-speaker effect.
Press
SPEAKERS A and/or B to turn off all speakers so you can
listen privately with headphones (see “Using Headphones” on
Page 11).
3. Select a program source.
To tune to a radio station, see “Direct Tuning (Remote Control
Only)” on Page 10.
To listen to signals from the component connected to the
TAPE
MONITOR
jacks, press TAPE MONITOR so TAPE MON appears.
To listen to a source other than the one connected to the
TAPE
MONITOR
jacks, press TAPE MONITOR so TAPE MON
disappears. Then press
CD, PHONO, or AUX (CD, PHONO, or
AUX appears).
4. Turn
VOLUME clockwise to increase the volume or
counterclockwise to decrease it. Or, you can use
VOLUME 9
and
8on the remote control.
5. To adjust the tone, turn
BASS and TREBLE toward + or –. To
increase the high and low ranges of sound at low volume, press
LOUDNESS. (To turn off this feature, press LOUDNESS again.)
6. To adjust the balance of sound between the left and right
speakers, see “Adjusting Balance” on Page 11.
7. When you finish using the receiver, press
POWER to turn it off.
USING THE SLEEP TIMER
The sleep timer lets you set the receiver to play for up to 90 minutes,
then automatically turns off.
1. To set the timer, turn on the receiver then press
SLEEP on the
remote control. The display dims and SLEEP 90 SLEEP
appears.
2. To set the sleep timer for less than 90 minutes, repeatedly press
SLEEP to decrease the time by 10 minutes for each press of the
button. Once you select the time, the receiver displays the
program source. (SLEEP stays on the display in small letters
until automatic shut-off.)
3. To briefly see the time remaining, press
SLEEP once.
POWER
PHONES
SPEAKERS
A/B
FM MODE
MEMORY
PRESET
SCAN
TREBLE
BASS
LOUDNESS
BALANCE
VOLUME
TUNING UP
TUNING DOWN
TUNING
MODE
AUX
CD
TAPE
MONITOR
FM
PHONO
AM