Manual

Location of Controls
Back Panel
........................................................................................................__ ........... _ c" _L_ON lj
CH3 CH4 Switch
Selects the channel to which you will tune the TV
to see the VCR picture if you connect the VCR
using one of the basic hookups.
IN FROM ANTENNA Connector
Receives the signal from an antenna, cable system,
or satellite receiver that is attached to this
connector.
OUT TO TELEVISION Connector
Passes signal to TV using the cable supplied.
VIDEO and AUDIO IN Jacks
Receives signals from another component, like
a VCR or camcorder, when it is connected to
these jacks. Use INPUT to select L1 in the
VCR's display panel.
VIDEO and AUDIO OUT Jacks
Sends signals from VCR to another component,
like a TV monitor or VCR, when it is connected
to these jacks.
Display Panel
This VCR has a feature where you can change the brightness level of the fluorescent
display panel.
1. Press MENUePROG on the remote to see the VGR MAIN
MENU on the TV screen.
2. Press 6 to display the PREFERENCES menu.
3. Press4 to select Panel Display: AUTO, BRIGHT, or DIM.
* Select AUTO to keep the display panel bright when VCR
is on and dim when it is off.
e Select BRIGHT to keep the display panel bright.
, Select DIM to keep the display panel dim.
VCR MAIN MENU
1 VCR PLus+
2 Timer Recordings
3 Time
4 Channels
PREFERENCES
1 Remote Control: VCRI
2 Auto Play: ON
5 CF Marking: ON
6 CF PLayback: AUTO
7 CF Display: BLUE
8 Set Auto Repeat
O Exit
42 continued on next page