High Capacity Case Trimmer Kit PRODUCT INSTRUCTIONS
WARNING Before using the RCBS High Capacity Case Trimmer kit, read these instructions carefully to fully learn how to safely operate the related reloading equipment. Failure to properly operate the related reloading equipment can result in severe personal injury and/or equipment damage. If you have any questions while assembling or operating this tool, Call us at 1-800-533-5000 or 1-530-533-5191 Monday – Thursday 6:30 am – 3:00 pm Pacific Time (hours may vary) Or email us at rcbs.tech@atk.
• Store primers and powder beyond the reach of children and away from heat, dampness, open flames and electrical equipment. Avoid areas where static electricity is evident. • Do not use primers of unknown identity. • Dispose of unknown primers in accordance with applicable regulations. • Keep primers in the original factory container until ready to use. Return unused primers to the same factory packaging for safety and to preserve their identity. Primer packaging is designed to provide safe storage.
TRIMMER ASSEMBLY 1. Select a solid bench on which to mount the High Capacity Trimmer Kit. You must use the four mounting holes (use casting as a template). Mounting hardware not included. Leave enough room to the left and right of the Trimmer Body to operate the Collet Handle and Trimmer Handle. 2. Place the Handle Assembly on the Cutter Shaft and secure the 10-32 Button Head Cap Screw with a 1/8” hex wrench (not included). 3. Select one of the three included Pilots for the cases you are about to trim.
2. Adjust the 8-32 SHSS Adjustment Bushing Stop so that approximately 1/8” is exposed to the left of the Adjustment Bushing. 3. Slide the Adjustment Bushing towards the Cutter roughly ½” and temporarily lock it in place with the 8-32 SHSS. 4. Loosen the two 6/32” SHCS with a 7/64” hex wrench that secure the Case Holding Collet assembly to the Base. This allows the Collet Assy to be moved to the right. 5. Slide the Cutter Assy to the LEFT until the Adjustment Bushing Stop is up against the Cutter Sleeve.
CASE LENGTH ADJUSTMENT 1. Shorter cases, such as the .416 Barrett, require the Collet Holder assembly to be moved closer in towards the cutter head. 2. Lock the case into the Collet Holder. The Adjustment Bushing should be positioned in the center of the Cutter Shaft. 3. Loosen the 6-32 Socket Head Set Screw with a 7/64 hex wrench and slide the Collet Holder assembly to the right. Slide the case mouth onto the Pilot while you are pushing the Cutter Shaft assembly to the left to center the case.
-7-
PRECISIONEERED RELOADING EQUIPMENT We think that we make the very best reloading equipment in the world. If you agree, please tell your friends. If you disagree, tell us we want to do something about it! Customer Service 1-800-533-5000 (US or Canada) or 530-533-5191 Hours: Monday - Thursday, 6:30am - 3:00pm Pacific Time (hours may vary) e-mail: rcbs.tech@atk.com or visit our website at www.rcbs.com RCBS 605 Oro Dam Blvd.E.
