Operation Manual

ENGLISH

8. Do not connect this product to any equipment or accessories not foreseen.

For suspended installation, only use the dedicated anchoring points and do not try to hang this

product by using elements that are unsuitable or not speciﬁc for this purpose.

Also check the suitability of the support surface to which the product is anchored (wall, ceiling,

structure, etc.), and the components used for attachment (screw anchors, screws, brackets not

supplied by RCF etc.), which must guarantee the security of the system / installation over time,

also considering, for example, the mechanical vibrations normally generated by transducers.

To prevent the risk of falling equipment, do not stack multiple units of this product unless this

possibility is speciﬁed in the user manual.

9. RCF S.p.A. strongly recommends this product is only installed by professional qualiﬁed installers (or

specialised ﬁrms) who can ensure correct installation and certify it according to the regulations in

force.

The entire audio system must comply with the current standards and regulations regarding electrical

systems.

10. Supports and trolleys

The equipment should be only used on trolleys or supports, where necessary, that are

recommended by the manufacturer. The equipment / support / trolley assembly must be moved

with extreme caution. Sudden stops, excessive pushing force and uneven ﬂoors may cause the

assembly to overturn.

11. There are numerous mechanical and electrical factors to be considered when installing

a professional audio system (in addition to those which are strictly acoustic, such as sound

pressure, angles of coverage, frequency response, etc.).

12. Hearing loss

Exposure to high sound levels can cause permanent hearing loss. The acoustic pressure level

that leads to hearing loss is different from person to person and depends on the duration of

exposure. To prevent potentially dangerous exposure to high levels of acoustic pressure, anyone

who is exposed to these levels should use adequate protection devices. When a transducer

capable of producing high sound levels is being used, it is therefore necessary to wear ear plugs

or protective earphones.

See the technical speciﬁcations in loudspeaker instruction manuals to know their maximum

sound pressure levels.

IMPORTANT NOTES

To prevent the occurrence of noise on microphone / line signal cables, use screened cables only

and avoid putting them close to:

• Equipment that produces high-intensity electromagnetic ﬁelds (for example, high power

transformers)

• Mains cables

• Loudspeaker lines.

OPERATING PRECAUTIONS

• Do not obstruct the ventilation grilles of the unit. Situate this product far from any heat

sources and always ensure adequate air circulation around the ventilation grilles.

• Do not overload this product for a long time.

• Never force the control elements (keys, knobs, etc. ).

• Do not use solvents, alcohol, benzene or other volatile substances for cleaning the external

parts of this product.