Operation Manual

24
ENGLISH
1.
MIX – MUSIC OFF
MIX: the selected AUX INPUT is always
present in the (mixed) signal sent to the
amplifier, even during a priority command.
MUSIC OFF: the selected AUX INPUT is
not sent to the amplifier during a priority
command.
2.
PRIO INPUT 1
PRIO INPUT 2
PR. IN1: the channel 1 has the highest
priority level with override (but the CHIME
SEQUENTIAL COMMAND) through the
relevant command (or VOX), if the dip-
switch no.3 has been set to ‘graduated
priority’.
PR. IN2: the channel 2 has the highest
priority level with override (but the CHIME
SEQUENTIAL COMMAND) through the
relevant command, if the dip-switch no.3
has been set to ‘graduated priority’.
3.
I/LCK – GR. PRIOR.
I/LCK: interlocked priority mode
(read the ‘Operation’ section).
GR. PRIOR.: graduated priority mode
(read the ‘Operation’ section).
4.
OFF – VOX ON IN1 OFF: the channel 1 VOX function is off.
VOX ON IN1: the channel 1 VOX function
is on (automatic priority when a signal is
detected on the audio INPUT 1).
5.
OFF – SMART IN2
OFF: the channel 2 priority is kept only
if the relevant command is still present
(‘push’ mode).
SMART IN2: the channel 2 priority is
switched on / off by every impulse of the
relevant command (‘toggle’ mode).
6.
OFF – SMART IN3
OFF: the channel 3 priority is kept only
if the relevant command is still present
(‘push’ mode).
SMART IN3: the channel 3 priority is
switched on / off by every impulse of the
relevant command (‘toggle’ mode).
7.
SHORT – CHIME LNG SHORT: short chime (before paging).
CHIME LONG: long chime (before
paging).
8.
SHORT – CHIME LNG
SHORT: the short chime is continuously
played when the ‘CHIME SEQUENTIAL
COMMAND’ is activated.
CHIME LONG: the long chime is
continuously played when the ‘CHIME
SEQUENTIAL COMMAND’ is activated.
i 8 dip-switches PRESET to set the priority options:
o CHIME LEVEL (a trimmer adjustable by using a small screwdriver).
p CHIME SEQUENTIAL COMMAND with removable connector (activated when the 2 pins are
short-circuited) to send the chime continuously (the chime type can be selected by the dip-
switch no.8, see 20-8).