Operation Manual

26
ENGLISH
DIP 2 DIP 3 MODE
I/LCK INTERLOCKED
Only the first priority command of channels 1÷4 (and also channel
1 VOX, if enabled through the dip-switch no.4) is accepted.
Any other priority command will not be accepted until the previous
is removed.
Note: the only event that can always be activated later (and
can override a previous priority) is the CHIME SEQUENTIAL
COMMAND.
PRIO IN1
GR. PRIOR.
GRADUATED
PRIORITY 1
A priority command having a higher level can override the previous one.
The priority levels are:
1. (highest) CHIME SEQUENTIAL COMMAND
2. channel 1 (including VOX)
3. channel 2
4. channel 3
5. channel 4
PRIO IN2
GR. PRIOR.
GRADUATED
PRIORITY 2
A priority command having a higher level can override the previous one.
The priority levels are:
1. (highest) CHIME SEQUENTIAL COMMAND
2. channel 2
3. channel 1 (including VOX)
4. channel 3
5. channel 4
i
The dip-switch no.2 (8 dip-switch group) allows you to switch the priority level between the
channels 1 and 2. This setting does not work in the interlocked priority mode.
As soon as a priority event ends, the initial state will be restored (the channels 1, 2, 3, 4 and the
selected aux input will be mixed together, unless another priority event is in progress).
CHIME SEQUENTIAL COMMAND
The CHIME SEQUENTIAL COMMAND makes the chime (short or long, depending on the dip-switch
no.8 setting, see 20) be continuously repeated. This command has the highest priority level and
always removes the selected aux input from the signal sent to the amplifier.
CHANNEL 2 - 3 ‘PUSH’ / ‘TOGGLE’ PRIORITY MODE
The dip-switches no.5 and no.6 (8 dip-switch group, see 20) allow choice of priority mode for
channels 2 and 3 between ‘push’ (the priority is kept only if the command is still present) and ‘toggle’
(the priority is switched on / off by every impulse of the command).
Note: the chosen priority mode is applied to both BM 3001 paging microphones (if present) and
priority commands (of removable connectors).
4 DIP-SWITCH GROUP (PER EACH CHANNEL 1÷4)
Each input gain can be set to either MIC or -20 dBu (0 dBu for the channel 1). It is also possible
to turn the PHANTOM power supply on/off, to insert / remove the high-pass filter and to enable /
disable the chime, which is played on every priority event.