Manual

14
ENGLISH
ENGLISH
INSTALLATION INSTRUCTIONS
• You are recommended to install the speaker safety,checking that the
fixing surface is resistant and solid enough to support the weight of the
speaker, so as to prevent the risk of it falling that could put the safety of
persons and structures in jeopardy.
• Do not tighten the screws to fix the speakertoo tightly so as not to risk
damaging the M6 threaded inserts.
The accessory is installed as follows (see
the figure 1):
1. Using 2 plugs (not provided), fix the
support at the chosen point on the wall.
The plugs
to be used must be chosen carefully
depending on the type of
wall(plasterboard, hollow bricks, solid
bricks, concrete, matchboard
panelling, etc.).
2. Couple the speaker to the support,
screwing the 2 screws withknobs P
supplied into the M6 threaded inserts of
the speakers, without tighten them.
3. Adjust the angle of the speaker and
tighten the knobs P firmly.
WARNING: Do not connect this product to any equipment or accessories
not foreseen.
For suspended installation, only use the dedicated anchoring points and
do not try to hang this loudspeaker by using elements that are unsuitable
or not specific for this purpose.
Also check the suitability of the support surface to which the product
is anchored (wall, ceiling, structure, etc.), and the components used for
attachment (screw anchors, screws, brackets not supplied by RCF etc.),
which must guarantee the security of the system / installation over
time, also considering, for example, the mechanical vibrations normally
generated by transducers.
RCF S.p.A. strongly recommends this product is only installed by
professional qualified installers (or specialised firms) who can ensure a
correct installation and certify it according to the regulations in force.
The entire audio system must comply with the current standards and
fig. 1
P
P