User manual

16
ENGLISH
Pressing the HOME button again gives access to the INFO page where the following is
shown:
FIRMWARE: firmware version - x.xx
BT ID: Bluetooth Identification – 123x
BT STAT: Bluetooth status - (OFF/PAIRING/ONLINE)
USB STAT: USB connection status - (OFFLINE/ONLINE)
Pressing the HOME button again gives access to the “I/0” MIXER ENABLE DISABLE page.
This menu allows to disable the mixer in an EVOX JMIX8 system. Turn the EDIT encoder
counterclockwise to change the menu line from MIXER ENABLE to MIXER DISABLE, press
the EDIT encoder, a display message will appear:
DISABLE MIXER – PRESS ENCODER TO CONFIRM – PRESS ANY KEY TO CANCEL
By pressing the EDIT encoder again, the mixer is disabled and the LCD display backlight
will switch off in 3 seconds.
Now the mixer is disabled, and the EVOX JMIX8 can be used like a conventional active
speaker using the XLR connection located on the subwoofer back panel as mono input.
To enable the mixer again, turn clockwise the EDIT encoder, the display will switch on
again, press the EDIT encoder and a display message will appear:
ENABLE MIXER – PRESS ENCODER TO CONFIRM – PRESS ANY KEY TO CANCEL
Pressing the EDIT encoder the EVOX JMIX8 mixer is enabled again and the system turns
to full operation.
16
SYSTEM button:
Pressing the button once gives access to the LOAD SHOW page;