User manual

ENGLISH

2. FLANGER

3. TREMOLO

Rotate the EDIT encoder to select a modulation type.

The two rotary controls allow to change the parameters of the selected modulation

preset: DEP (Depht) from 0 to 100%, and RATE (rate) in Hz.

The MOD ON/OFF box allows to bypass the modulation module.

DLY page:

The Delay page shows three rotary controls to edit the DELAY effect: LEV (level), TIME

(Delay time) in ms, FDBK (Delay feedback). Set these parameters to create the favorite

delay effect. The DLY ON/OFF box allows to bypass the delay module.

FX button:

Pressing the FX button gives access to the internal effects edit page.

FX PRESET menu allows to select the FX presets:

01 – 40 – REVERBS 41 – 60 – DELAYS

61 – 80 – MODULATIONS

Select a preset rotating the EDIT encoder and conﬁrm the selection pressing it. The ON/

OFF box permits to switch the effect send (FX) on and off.

Each program shows two editable parameters and an effect return level control. The

editable parameters for REV programs are:

DEC (sec) – Decay in seconds

DAMP – Frequency Damping

For DLY programs:

TIM (ms) – time in milliseconds

FDBK – Feedback

For MOD programs:

RATE – rate (in Hz)

DEPTH – depth

PAIR button.

Pressing the PAIR button initiates the Bluetooth discovery sequence, required when a new

pairing operation has to be performed on a smartphone, tablet or notebook. The green

LED will blink as long as a Bluetooth device is associated. When the device is connected,

the green LED will be steadily lit. Now it is possible to control the EVOX JMIX8 system via

the Android or iOS app. Furthermore, a Bluetooth audio streaming is enabled to stereo

channel 7/8 (see section 10 of this chapter)

USB.

The “type B” USB connector is used for future ﬁrmware upgrades.