User's Manual

11
ENGLISH
SETTING YOUR
MYTHO
OFF
- 3 dB
WALL/CORNER
PLACEMENT
BASS ROLL-OFF
SETTING
OFF
- 1 dB
- 2 dB
- 4 dB
SMALL
ROOM
BASS TILT
SETTING
- 2 dB
- 1 dB
0 dB
+ 1 dB
ROOM
ACOUSTICS
TREBLE TILT
SETTING
OFF
ON
MYTHO
ON YOUR
DESKTOP
DESKTOP
CORRECTION
SETTING
LINEAR PWR RESP.
LINEAR FREQ. RESP.
ROOM
ACOUSTICS
EQUALISATION
SETTING
The low frequency attenuation is necessary when
loudspeakers are placed near the room walls or
corners. The amount will depend on the specific
situation (in general -3 dB for wall placement and
-6dB in case of corner placement).
It corrects the progressive increase of mid-low and
low frequencies due to resonances in small rooms.
The amount of correction will depend on the size
and shape of the room (a bigger correction for
smaller and regular shaped rooms). A large room
shall require no correction.
It corrects the woofer mid-frequencies emission in
small rooms. When the room is small the amount of
reflections from the walls is bigger for the very low
and mid-low frequencies that will tend to be to be
predominant compared to mid frequencies in
case of same axial emission. Set to LINEAR
POWER response to compensates this lack of mid
frequencies from the woofer channel. In medium
to large rooms, where the wall reflections tend to
be negligible, this switch must be set in the LINEAR
FREQUENCY response.
A room can be very dull or very bright depending
on wall materials. This filter help to correct the
behaviour in the high frequencies for a specific
room. For a normal room no correction shall be
applied (0 dB position). For a dull room the treble
tilt filter shall be set at +1 dB. The filter shall be set
at -1 dB or -2 dB for a bright or very bright room.
If Mytho Monitors are placed in this positions set
this switch ON to obtain a linear listening. This filter
reduces the emission in the frequency range (centred
in the 150 Hz octave) that is usually boosted when
studio monitors are directly placed on a reflective
surface (e.g. the mixing desk, a table, etc.).
- 6 dB