Microphone User Manual

ENGLISH

EQUALIZER SWITCH

The DSP power makes it possible to equalise the audio signal; this function

has been implemented in a totally independent way from the feedback

suppression.

• SPEECH: The frequency response of the radiomicrophone is perfectly

ﬂat. This selection is recommended for speech only.

• MUSIC: In this position, thanks to the DSP processing, middle, mid-bass

and bass tones are appropriately emphasised to make the microphone

sound warmer, mellow and “round”; the voice takes on fullness and

presence, so this option is particularly suitable to sing.

TRANSMITTER / HAND-HELD MICROPHONE TX 1000

TRANSMITTER / HAND-HELD MICROPHONE EQUIPPED WITH:

• Electret cardioid microphone.

• ON/OFF switch for the transmitter.

• MUTE switch.

• LED indicating the battery charge status.

USE:

• (!) Make sure the power switch is in the OFF position before inserting

the batteries.

• To access the battery compartment, remove the cover by pressing the

button and turning

the cover outwards at the same time.

• Insert a 9 V alkaline battery according to the polarity indications (+/-)

printed on the bottom and put the cover back on.

• Turn on the transmitter using the switch on the battery cover: the red

LED should stay lit only for a few seconds; if it stays lit longer, the battery

is very low and should be replaced.

• Make sure the MUTE switch (on the upper part, near the mic. capsule) is

set to MIC.

• Check the transmitter is working correctly: one of the two green LEDs

A/B on the respective receiver should be lit.