Installation Instructions

Valve

Venturi

Valve

Venturi

1. Remove the grates and burner covers to expose the stainless steel burners. Remove the

exisng burner where you intend to place the IR burner toward the back of the grill. On the

RJC style grill, simply unscrew the Phillips style screw on the rear of the burner and carefully

li out the burner towards the rear of the grill to remove. ( on RJC style grills you must

remove the cross over bracket in rear by removing two screws).

2. Place the IR burner in the same posion as the burner was once in. On RJC grills there is

a mount with a hole, simply place the tab on the IR burner in the posion where the burner

mount once was. It will locate on it’s own.

3. Make sure the new IR burner is lined up on the valve correctly. The valve stem should be

posioned inside the burner venturi about 1/4” to 1/2”. ( see diagram below).

4. To start the IR burner, slowly turn the valve to create gas ow, then hold for 5 seconds

before the ignion click. Connue turning to acvate spark and piezzo ame thrower. Hold

for 3 seconds to insure ignion.

5. IR burner should turn bright orange and emit about 1400 to 1600 degrees F infrared heat.

6. Be sure to ALWAYS KEEP HOOD OPEN when using IR burner and ONLY use on High Seng.

Infra Red can not be used

Side View

RCS InfraRedBurner Installaon 7.26.13.pub

PAGE 1
. Remove the grates and burner covers to expose the stainless steel burners. Remove the existing burner where you intend to place the IR burner toward the back of the grill. On the RJC style grill, simply unscrew the Phillips style screw on the rear of the burner and carefully lift out the burner towards the rear of the grill to remove. ( on RJC style grills you must remove the cross over bracket in rear by removing two screws). 2. Place the IR burner in the same position as the burner was once in.