Gas Valve Alignment Instruction Manual

2 Remove cooking grids from grill

a. Check to see if the igniter is centered in the hole.

Look inside the grill at the front inside panel where the burner goes through housing.

igniter?

First

If your grill still will not ignite, please check the following

Upon inspection, if you find that your igniter is off-centered, follow these steps.

Remove heat tents from grill

Align Igniter with the center of the cut-out hole

If not, Take your hand and push the valve to make the igniter centered

(You can either use a flat head screw driver to align the valve or use your hand by reaching

underneath the control panel and rotating valve to align the igniter with the center of the

hole.) DO NOT PRY ON THE WHITE CERAMIC PIECE

Gas Valve Igniter Alignment

This guide is for the RCS main burners not igniting when the valve clicks over.

Are you waiting pushing in the knob & holding for 2-3 seconds before clicking the

Check to make sure you have your main gas supply open.

Will your grill light manually with a long lighter? If so, proceed with steps below.

Step 1:

www.RCSGasGrills.com

Turn off the gas supply to the grill

PAGE 1
Gas Valve Igniter Alignment First This guide is for the RCS main burners not igniting when the valve clicks over. Check to make sure you have your main gas supply open. Will your grill light manually with a long lighter? If so, proceed with steps below. Are you waiting pushing in the knob & holding for 2-3 seconds before clicking the igniter? If your grill still will not ignite, please check the following Upon inspection, if you find that your igniter is off-centered, follow these steps.
PAGE 2
If igniter is not igniting gas after completing step 1 please continue with step 2 below. Step 2: Bend tab on end of igniter Tools Needed: Turn off the gas supply to the grill 1 - Needle Nose Pliers Remove Cooking Grids Remove Heat Tents Remove Burners a RON27a, RON30a, RON36a, & RON42a Grills. Remove clip and burner will slide back and out of the grill. b There are bolts at the back of the burner holding the burner in place on the RJC26a & RJC32a Grills.