User Manual

Rotisserie Burner Conversion:
1- Remove the back panel at the rear of the grill, this will expose the V shaped or
pyramid shaped brass orifice.
2- Remove the existing orifice and replace with change out orifice.
3- Replace rear panel
Trouble Shooting
Problem Solution
Burner will not light - Check gas supply to burner by manually
lighting the burners.
- See electrode for visible damage, replace if damaged.
Improper burner flame -Check burner gas inlet area for blockage
- Check orifice hoods for any clogging and clean.
- Adjust air shutter, if necessary.
- Check pressure if flame is too low or too high.
- Check gas supply tank (LP) if running low.
Light is not ON - Connect 115V power at rear. Turn switch ON.
- Make sure the transformer was used in installation and
your grill was NOT hooked up directly to 115 volt power
source.
- Check bulb. Replace if necessary.
- Check any GFCI plugs in line.
25 | Page