manual

ManualsBrandsRCS ManualsDomestic AppliancesRWD1

RCS Warming Drawer

Instruction Manual

Model Number: RWD1 36"

Electric Warming Drawer

Rated 120V, 60 Hz, 8A

Electrical: 1

20 Volt, 60 Hz, AC Only 15- or 20- amp.

Use copper wire only.

A time-delay or circuit breaker and

separate circuit is recommended.

TABLE OF CONTENTS PAGE #

SAFETY INSTRUCTIONS………………………………………………………………………………………………………………………… 2

INSTALLATION INSTRUCTIONS…………………………………………………………………………………………………………….. 3

OPERATING INSTRUCTIONS…………………………………………………………………………………………………………………. 4

CLEANING & MAINTENANCE……………………………………………………………………………………………………………….. 5

TROUBLESHOOTING GUIDE………………………………………………………………………………………………………………… 5

PARTS LIST…………………………………………………………………………………………………………………………………………… 6

WARRANTY………………………………………………………………………………………………………………………………………….. 6

READ THE

FOLLOWING INSTRUCTIONS CAREFULLY AND BE SURE YOUR WARMING DRAWER IS

PROPERLY INSTALLED, ASSEMBLED AND CARED FOR. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY

RESULT IN SERIOUS BODILY INJURY AND/OR PROPERTY DAMAGE, IF YOU HAVE QUESTIONS

CONCERNING ASSEMBLY OR OPERATION, CONSULT YOUR DEALER OR APPLIANCE SERVICE

REPRESENTATIVE.

NOTE TO INSTALLER:

LEAVE THESE INSTRUCTIONS WITH THE CONSUMER AFTER INSTALLATION.

NOTE TO THE CONSUMER:

RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.

THIS OUTDOOR COOKING ELECTRIC APPLIANCE IS NOT INTENDED TO BE INSTALLED IN OR ON

RECREATIONAL VEHICLES

AND/OR BOATS.

Summary of content (6 pages)

PAGE 1
RCS Warming Drawer Instruction Manual Model Number: RWD1 36" Electric Warming Drawer Rated 120V, 60 Hz, 8A Electrical: 120 Volt, 60 Hz, AC Only 15- or 20- amp. Use copper wire only. A time-delay or circuit breaker and separate circuit is recommended. TABLE OF CONTENTS PAGE # SAFETY INSTRUCTIONS………………………………………………………………………………………………………………………… 2 INSTALLATION INSTRUCTIONS…………………………………………………………………………………………………………….. 3 OPERATING INSTRUCTIONS………………………………………………………………………………………………………………….
PAGE 2
SAFETY INSTRUCTIONS Read carefully before operating your warming drawer Electrical Requirements Important: Observe all governing codes and ordinances. It is the customer's responsibility: To contact a qualified electrical installer. To assure that the electrical installation is adequate and in conformance with National Electrical Code. ANSUNFPA 70 — latest edition* or CAN/CSA-C22.2 No. 0-M91 CANICSA-022.2 No. 0.4-04 CANSCSA-C22 2 No. No. 64-M91 UL 1026, 5Th Edition and all local codes and ordinances.
PAGE 3
INSTALLATION INSTRUCTIONS Island Installation 1) Provide a 10 1/8" H x 34 1/2" W x 21" D cutout to the front of the island. 2) Provide support beams using metal studs. 3) Pull the drawer out of the drawer casing to gain access to the mounting holder at the front of the casing. 4) Insert the drawer casing into the island opening. 5) Secure the drawer casing with screws at the inside front top and bottom, using the pre-punched mounting holes. 6) Re-assemble the drawer section into the drawer casing.
PAGE 4
OPERATING INSTRUCTIONS Temperature Controls The temperature control dial is used to select the temperature of the warming drawer. It is located on the right hand side of the control panel and has dial settings from 50°F-230°F. The warming drawer should only be opened when adding or removing food. Continuous opening of the drawer allows warm air to escape and make the food colder. Do not use aluminum foil to line the drawer. Foil is an excellent heat Insulator and will trap heat beneath it.
PAGE 5
CLEANING & MAINTENANCE The Warming Drawer is made of welded #304 stainless steel. 1. Allow the warming drawer and its accessories to cool before cleaning. 2. Clean all items including the drawer with the mildest cleanser. Scrub dirt with sponge. 3. When cleaning the front panel, always scrub in the direction of the grain. In order to maintain the luster and highlights of polished surface, do not use abrasives when cleaning polished surfaces. Use the mildest cleaner. 4.
PAGE 6
PARTS LIST & WARRANTY Model Number: RWD1 36" Electric Warming Drawer, Rated 120V, 60 Hz, 8A 1) Heating Element 6) Roller Guides 2) Thermostat 7) Drawer Handle 3) Chrome Bezel 8) Handle Bracket 4) Heat on Light 9) Drawer 5) Control Knob 10) Steam Pan Guide HOW TO ORDER REPLACEMENT PARTS Please refer to the parts list on this page. To make sure you obtain the correct replacement parts for your warming drawer, the following information is required to assure getting the correct part. 1.