User's Manual

4
switch from one camera to the next either manually or automatically via button on
the top panel of the receiver.
MANUAL MODE
To select one of the three channels manually, press the MANUAL button on the
panel of the receiver.
The receiver will switch to a different channel (CAM1, CAM2) each time when the
MANUAL button is pressed. To avoid searching channels that do not have
cameras/transmitters assigned to them, set the DIP switches (located on the rear
panel of the receiver) for those corresponding channels to the OFF position (up).
When you have selected a channel with an active camera, that video will appear
on your TV screen
AUTO MODE
To have the receiver automatically rotate through the channels, press the AUTO
button on the top panel of the receiver. The receiver will continuously scan
through all channels which are ON. To avoid searching channels that do not have
cameras/transmitters assigned to them, set the DIP switches for those
corresponding channels to the OFF position. The monitor will display the picture
from one camera to the next, while the beeper will sound. The dwell time (time
taken to switch between cameras) is preset to 4 seconds and can be adjusted
between 2-30 seconds. To adjust the dwell time, press both the AUTO and
MANUAL button simultaneously. Each flash of the LED increases the dwell time
by one second.
TROUBLE SHOOTING
If you are having trouble operating this product, please consult the guide below:
SYMPTOM REMEDIES
No camera picture
1. Check all connectors. Make sure camera(s) and
receiver are switched ON.
2. Ensure camera(s) and receiver are set to correct