User's Manual

Sound Trigger
When the sound detected by the camera is above preset level*, the monitor will be
triggered to alarm. This will happen in two circumstances, 1) the monitor is in P/S mode, 2)
the monitor is in MUTE** mode.
*The level is preset by manufacturer, can not be adjusted by users.
**When the sound detected by camera is under a preset level(preset by manufacturer
only, a very low level), the monitor will shut down the speaker so that you won’t get
disturbed by environmental noise. This is MUTE mode.
Install the Camera
1. Carefully unpack the Camera.
2. Mount the camera to the wall:
Mark the position of the screw holes on the wall.
Drill holes and insert 2 screws.
Firmly attach the camera to the wall by placing
the stand over the installed screws and pushing the
base downwards to secure.
NOTE: The camera can also be placed on a flat
surface, such as a Table or Shelf, and no mounting
hardware is required.
3. Adjust the Viewing angle of the Camera.
Connecting Camera Power
The Camera can be powered either by using the provided Power Adapter, or using
rechargeable battery pack(not included).
NOTE: Wireless camera requires a power source (either an electrical outlet or battery
power) to operate.
If you plan to permanently mount the camera in a location, it is recommended to use the
included Camera Power adapter to prevent interruptions in the image, as using battery
power is intended as a temporary power solution.
Camera Positioning
The Camera can be placed on a flat surface, or
wall mounted. The versatile stand allows for
several different mounting options.
- 6 -