User's Manual

Night Vision

This camera has built-in IR LEDs, which provides the camera with the ability to view images in no/low

light conditions. It is important to use the provided power adaptor (and not the batteries) when using the

camera for prolonged periods in low light conditions, as the built-in IR LEDs will drain the battery more

quickly than regular daytime use.

Camera Installation

Before you install the camera, carefully plan where and how it will be positioned, and where you will

route the cable that connects the camera to the power adaptor.

Before starting permanent installation, verify its performance by observing the image on the receiver

when camera is positioned in the same location/position where it will be permanently installed and the

receiver is placed in the location where it will be used most of the time.

1. Carefully unpack the camera.

NOTE: If you are installing cameras that did not come with the system, please see the pairing camera

section of this manual for details on installation.

2. Mount the camera to the wall or put it on a cabinet, table or shelf. To mount the camera on the wall,

Mark the position of the 2 screw holes on the wall, and drill holes and insert the included plugs and

screws, Firmly attach the camera to the wall by placing the base over the installed screws and pushing

the base downwards.

3. Pointed the camera of the baby unit towards the area you want to monitor. The camera can be tilted

and swiveled to point it at the baby. For good sensitivity it is recommended to place the camera no more

than 3 meter away from the baby

NOTE: You can install additional cameras (maximum of 4 cameras). When adding cameras that were

not included in the original box, you will need to pair up the cameras with the receiver. Refer to the

camera pairing section of this manual.

Installation Warnings

Aim the camera(s) to best optimize the viewing area: Select a location for the camera that provides a

clear view of the area you want to monitor, which is free from dust, and is not in line-of-sight to a strong

light source or direct sunlight.

Avoid installing the cameras where there are thick walls, or obstructions between the Cameras and the

Receiver.

Do not install camera in those area which is easy for baby to touch; Make sure the camera is installed

stable and not fall down.