User's Manual

A:To update firmware from server
1. Connect the included Ethernet cable from the Ethernet
port on the receiver to your router. The new download icon
(
) appears on the screen if new firmware is available.
2. Press Menu, then press the joystick to select Settings.
3. Select Firmware Upgrade.
4. Select From Server, then select Yes.
The system takes a few moments to install the latest
firmware.
5. After upgrading the new firmware, the monitor will
automatically reboot .
CAUTION: During upgrading ,insure the connection of network is okay and do not plug out
power during upgrading.
B:To update firmware from SD card
1. Insert the SD card into the included adapter. Insert the adapter into the SD card reader (not included)
on your PC or Mac.
2. Download the latest firmware and transfer it to the root folder on the SD card.
3. Once the transfer is complete, insert the SD card into the card slot on the receiver.
4. Press Menu, then press the joystick to select Settings.
5. Select Firmware Upgrade and press OK to confirm.
6. Select From SD Card, then selected Yes. The system takes a few moments to install the latest
firmware.
7. After upgrading the new firmware, the monitor will automatically reboot .
CAUTION: During upgrading , do not plug out power during upgrading.
-Network:
Configure the receiver’s IP address (advanced), view network information, or reset your
remote access password.
1.Netwroking setting: IP Addressing Options,to select the
Static IP and Dynamic IP
CAUTION:This section is for advanced users only.
Note
• Dynamic IP addressing is enabled by default.
• A static IP address is not required for remote access to
the system.
• You may have to configure your router settings if the
DHCP server is enabled.