User's Manual

Night Vision
This camera has built-in IR LEDs, which provides the camera with the ability to view images in no/low
light conditions. It is important to use the provided power adaptor when using the camera for prolonged
periods in low light conditions, as the built-in IR LEDs will drain power more quickly than regular
daytime use.
Night vision will be automatically switched on in low illumination condition.
1. Carefully
unpack the Camera.
NOTE: If you are installing Cameras that did not come with the system, please see the Pairing Camera
section
of this manual for details on installation.
2.
Mount the camera to the wall:
Mark the position of the screw holes on the wall, drill holes and insert the supplied 3 plastic anchors, then
firmly fix the camera bracket to the plastic anchors with supplied screws.
NOTE: The camera can also be placed on a flat surface, such as a Table or Shelf, and no mounting
hardware is required.
3.
Adjust the Viewing angle of the Camera.
You can adjust the viewing angle to monitor desired area by rotating the camera bracket. Here are some
templates:
Connecting Camera Power
After the camera is installed, plug the AC adaptor power output cable into
the 9V POWER jack of the camera, and plug the power plug into a wall
outlet or surge protector.
NOTE: You can install additional cameras (maximum of 4 cameras). When adding cameras that were
not included in the original box, you will need to pair the cameras with the receiver. Refer to the camera
pairing section of this manual.
Make sure is the DC 9V for camera, and DC 5V for Receiver
Make sure the power adaptor is placed into a grounded outlet or surge bar to protect the camera from
power fluctuations.