User's Manual

8. Speaker – Produces the sound transmitted from the receiver.

Back Controls

9. Pair Button – The pair button is located on the back of the camera,

it is used to pair the camera with receiver.

10. Bracket Jack – Screw the wall mounting bracket to the jack, and

fix the bracket on a wall or other flat surfaces.

Camera Installation

Before you install the camera, carefully plan where and how it will be positioned, and where you will

route the cable that connects the camera to the power adaptor.

Before starting permanent installation, verify its performance by observing the image on the receiver

when camera is positioned in the same location/position where it will be permanently installed and the

receiver is placed in the location where it will be used most of the time.

Installation Warnings

Aim the camera(s) to best optimize the viewing area: Select a location for the camera that provides a

clear view of the area you want to receive, which is free from dust, and is not in line-of-sight to a strong

light source or direct sunlight.

Avoid installing the cameras where there are thick walls, or obstructions between the cameras and the

receiver.

Night Vision

This camera has built-in IR LEDs, which provides the camera with the ability to view images in no/low

light conditions. Night vision will be automatically switched on in low illumination condition.

Installing the Camera

1. Carefully unpack the camera.

NOTE: If you are installing cameras that did not come with the system, please see the pairing camera

section of this manual for installation details.

2. Mount the camera to the wall.

Mark the position of the screw holes on the wall, drill holes and insert the supplied 3 plastic anchors, then

firmly fix the camera bracket to the plastic anchors with supplied screws.

3. Adjust the viewing angle of the camera

You can adjust the viewing angle to monitor desired area by rotating the camera bracket.

4. Connect camera power

After the camera is installed, plug the AC adaptor power output cable into the 9V POWER jack of the

camera, and plug the power plug into a wall outlet or surge protector.

NOTE: You can install additional cameras (maximum of 4 cameras). When adding cameras that were