User's Manual

channels to the OFF position.
The dwell/cycle time (time taken to switch between cameras) is preset to four seconds and can be
adjusted between 2-30 seconds. To adjust the dwell/cycle time, press both the AUTO and
MANUAL buttons simultaneously. Each flash of the LED increases the dwell time by one second.
MANUAL
To select a specific Camera to LCD Monitor, press the MANUAL button. The LCD Monitor will
switch to a different Camera each time the MANUAL button is pressed. To avoid searching
channels that do not have Cameras assigned to them, set the dip switches (located on the back
panel of the LCD Monitor) for those corresponding channels to the OFF position.
Monitor Functions ///
POWER
Press to turn the Monitor on/off.
ALARM VOLUME
The ALARM VOLUME of the LCD Monitor can be adjusted by tuning the Alarm Volume tuner
on the side of the LCD Monitor.
VOLUME
You may adjust the Sound Level by pressing “+” or “-” on the Volume button.
BRIGHTNESS
You can press "+" or "-" on the right side of the LCD Monitor to adjust the brightness of the
picture if necessary.
Trouble Shooting ///
If you are having trouble operating this product, please consult the guide below;
SYMPTOM REMEDIES
No camera picture 1. Check all connectors. Make sure camera (s) and monitor
are switched ON.
2. Ensure camera (s) and monitor are set to correct channel(s)
3. Make sure camera is within range of monitor (receiver).