User's Manual

The Camera/Transmitter installation is now complete.
Monitor/ Receiver
1. Unpack the Monitor/Receiver.
2. Plug the monitor power adapter into the power jack and plug the
power adapter into any AC power outlet. Turn on the monitor by
pressing front push button. Alternatively remove the battery
compartment lid on the underside of the unit and install 10 x C type
batteries (not included).
3. The Monitor/ Receiver installation is now complete.
Optimizing the 45235 BW Wireless mon Video System
The 900MHz video signals pass easily through your home’s interior
walls, but the signal may be reflected by power wires or plumbing
inside the wall. Usually a slight adjustment of the Monitor/Receiver
and/or Camera/Transmitter antenna will improve reception. Take care
not to force the antennas past their lock positions.
Sound level can be adjusted using the volume control knob on the
front of the Monitor/Receiver.
Adjust Brightness/Contrast as required using controls on the rear of
the Monitor/Receiver.
If needed the Vertical Hold can also be adjusted at the rear.
Adjust sound trigger sensitivity as required using controls on the rear
of the monitor.
The alert volume can also be adjusted on the rear of the monitor.