User's Manual

the “Auto” LED indicator will turn green. When the sound from
cameras is great than monitor’s presetting level, an audio alert will
sound; you need to check which camera was triggered by the sound.
To avoid searching empty channels, which do not have a camera
connected, make sure the slide switch on the rear of the
Monitor/Receiver has the corresponding switch in the correct position
for each camera. Example shows a 2-camera installation.
Cycle Time Setting (Time taken to switch between cameras)
To alter the cycle time press both of the buttons on the front of the unit
simultaneously. Each beep is one extra second of cycle time added.
The cycle time can be verified by flashing LED when you release, one
flash stand for one second. Cycle time can be set between 2-30
seconds. The cycle time is preset to 4 seconds.
USING THE 45235 SYSTEM WITH A VCR
You can connect a VCR to the 45235 System. This allows you to
record the picture from your Monitor/Receiver.