User's Manual

ManualsBrandsRDI Technology ManualsElectronicsWIRELESS DOOR SENSOR

Introduction

Congratulations on your purchase of the XANBOO homesight™ Wireless Door/Window Sensor. The Door/Window

Sensor uses a magnetic field to enable you to monitor the opening or closing of a door, window, cabinet, or whatever

else needs to be checked for movement. This Quick Start Guide describes how to set up and troubleshoot your

Door/Window Sensor.

Controlling Your Sensor

Using your computer and the Wireless System Controller, you locally manage your home environment with the

XANBOO homesight software. When configured, the system can notify you of any new events by sending an e-mail

when your Door/Window Sensor detects an event. An event is defined as the opening or closing of a

door/window/cabinet, etc.

How It Works

The sensor monitors the status of the magnetic contact. When a

change is detected with an opening or closing of a monitored door

or window, the sensor sends a notice of the event to your Wireless

System Controller, if enabled in Event Setup. The example shows

a Door/Window Sensor that has

been triggered when the door opens.

Installation Overview

Your package contains the following:

Installing your sensor is a simple process.

1. Insert the batteries. On the bottom of the sensor, slide open the door and

insert two AAA alkaline batteries. The back of the battery door of the sensor

indicates the polarity (+ and -) of the batteries. Close the door after inserting

batteries.

2. Register your sensor with your Wireless System Controller using a process called Discovery. Refer to your

homesight Software User Guide for instructions on how to discover your Wireless Door/Window Sensor.

Remark:

Antenna is permanently attached or has a unique connector

Feature Locator

Summary of content (6 pages)

PAGE 1
Introduction Congratulations on your purchase of the XANBOO homesight™ Wireless Door/Window Sensor. The Door/Window Sensor uses a magnetic field to enable you to monitor the opening or closing of a door, window, cabinet, or whatever else needs to be checked for movement. This Quick Start Guide describes how to set up and troubleshoot your Door/Window Sensor.
PAGE 2
Installation Hints Please consider the following points when mounting the sensor: z The XANBOO homesight Door/Window Sensor is constructed of UV resistant ABS plastic allowing for indoor or outdoor use. z The homesight Wireless Door/Window Sensor is constructed of UV-resistant ABS plastic. If installing the Wireless Door/Window Sensor outside, it should be shielded from the elements, such as underneath a porch roof. Do not install the sensor where it is subjected directly to the elements.
PAGE 3
Frequency Range: 418 MHz Typical Range Open air (line of sight): 200 feet (60 m) Typical Range Indoors: 60 feet Sensor size: (18 m) 3.43"L × 1.61"W × 0.59"H (87mm × 41mm × 15mm) Wall Mount Drilling Template Mounting tools: Screwdriver, electric drill or awl. On hard surfaces, XANBOO recommends that you pre-drill ½-inch deep pilot holes with a drill bit slightly smaller than the bracket mounting screws before securing the bracket to the surface.
PAGE 4
FAQ How far away can the sensor be placed from my Wireless System Controller? Typically 60 feet (18 m). Can I place the sensor in a different room than my Wireless System Controller? Yes, the sensor and Wireless System Controller use radio frequencies to communicate with each other. These frequencies can go through objects like walls, ceilings and floors. How long will the battery last? The battery is expected to last up to 12 months. This depends on actual use and how often the sensor is triggered.
PAGE 5
This device complies with Part 15 of FCC Rules. Operation of the device is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference that may cause undesired operation. FCC NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user's authority to operate the equipment.
PAGE 6
THIS PRODUCT EMPLOYS WIRELESS TECHNOLOGY AND, IN SOME CASES, MAY FACILITATE TRANSMISSION OF DATA OR VIDEO OVER THE INTERNET IN CONNECTION WITH ITS USE. THE CUSTOMER SHOULD UNDERSTAND THAT ALL WIRELESS TRANSMISSIONS MAY BE SUBJECT TO INTERCEPTION AND THAT DATA TRANSMISSION OVER THE INTERNET CANNOT BE GUARANTEED TO BE 100% SECURE.