Installation Guide

ENGLISH
6
(Fig. 15)
12.
Align the striker along the edge of the gate
upright, in the closed position with the latch.
Mark the two holes on the front of the striker
(Fig. 15). Mark the third hole on the side of
the striker, and pre-drill all three holes of the
striker using a
3
/
32
" drill bit. Secure striker to
gate using three 1" screws.
11.
Once hinges are installed and gate is aligned,
place the latch template at desired height
at the edge of the post closest to the gate.
Mark and pre-drill holes using a
5
/
8
" drill bit
for the center screw hole and using a
3
/
32
"
drill bit for the top and bottom screw holes
(Fig. 13).
Align the latch to the pre-drilled holes and
secure to post using two 1" screws (Fig. 14).
10.
Once gate is aligned and adjusted correctly,
snap on decorative hinge covers (Fig. 12).
(Fig. 14)
(Fig. 13)
(Fig. 12)