Installation Guide

5
ENGLISH
4.
Mark the center point of the post on
the beam or roof where the post will be
installed (Fig. 6).
Hang a plumb bob from the center point,
which you marked on the beam or roof, and
locate that point on the mounting surface
below (Fig. 7).
5.
Attach a post base to the beam or roof
centered over the point established in
Step 4, attach using 4 wood screws or
appropriate fasteners (Fig. 8). Do not forget
to place the gasket between the framing
and the base plate if installing on ACQ
lumber. Repeat for the bottom post base.
Be sure that both top and bottom base
plates are properly aligned. This can be
done using a level and straight edge or a
plumb bob (Fig. 9, 10, 11, and 12).
6.
Adjust position of bottom 8" centering
block 1" from bottom of Aluminum
Structural Column (Fig. 13).
Set middle 8" centering block so that its
midpoint will be located at the center of the
top railing bracket, if railing will attached to
the post (Fig. 14).
(Fig. 13)
(Fig. 7)
(Fig. 6)
(Fig. 9)
(Fig. 11)
(Fig. 12)
(Fig. 10)
(Fig. 8)
(Fig. 14)