Installation Guide

6
ENGLISH
(Fig. 20)
7.
Insert Aluminum Structural Column into the
bottom of the Vinyl Sleeve
Slide 4" centering lock around the
Structural Aluminum Column and press into
the top of the Vinyl Sleeve. Slide block 1"
past aluminum column to allow for base
plate (Fig. 15).
8.
Install post by aligning Structural Aluminum
Column over the circular portion of the
bottom aluminum base plate (Fig. 16).
Once seated on the base, lower the Vinyl
Sleeve over the raised tabs at the outside
of the base (Fig. 17). Now with top base
plate aligned over Porch Post, lower roof
structure into place (Fig. 18 & 19).
9.
OPTIONAL: Install Adjustable 4 piece
Trim Ring (73018131). To size the 4-piece
Ratchet-lock Trim Collar, refer to the markings
on the underside of each piece.
Tip:
4" posts will require all 8 pieces to be
trimmed to 4" mark. 5" posts will require all
eight pieces to be trimmed to 5" mark.
Snap the trim collars together at the top
and bottom of the turned porch post (Fig.
20). Slide each trim collar tightly against the
mounting surface and secure to the vinyl
post sleeve with vinyl adhesive, if desired.
(Fig. 15)
(Fig. 17)
(Fig. 16)
(Fig. 18)
(Fig. 19)