Instructions / Assembly

8
6.4. 5.
(Fig. 8)
(Fig. 9)
(Fig. 13)
Positionthelowerextrusionaligning
itwiththeproposedrailingdirection
(Fig.8).Ensurethatthepre-
mountedtopcenteringextrusionis
aligned as well.
Note:
RDIrailingkitsaremanufactured
fora36”or42”finished-railheight
witha2”standardbottomspace.
Ifotherheightsorbottomspaces
aredesired,adjusttheheightofthe
centeringextrusionaccordingly.
Note:
IfinstallingEndurance
®
ADA
HandRailontopost,determine
themountinglocationandcreate
sufficientattachmentbyblocking
outpostwith1”materialorby
purchasingathirdcentering
extrusionandinstallingatdesired
location(Fig9).
Slidethevinylsleeveoverthe
centeringextrusion.Markandcut
the sleeve to length.
Tip:
Thesleeveshouldextendabovethe
desiredrailheightenoughtoallow
clearanceforapostcap(Fig.10).
Note:
Ifusingaturnednewelsleeve*,be
suretoleaveenoughflatareatoac-
ceptrailattachmentbrackets(Fig.
11).Removethetopcenteringextru-
sionsetscrewandtheextrusion.
Usethisscrewtoattachthebottom
centeringextrusiontothepost.Slide
thetopextrusionontothepostafter
theturnedsleevehasbeeninstalled.
*Endurancerailkitsmeasure34”or
40”fromthebottomofthebottom
railtothetopofthetoprail.
Slidethecutvinylsleeve
overthestructuralpostandthecen-
teringextrusions(Fig.12).
Note:
Thetopcenteringextrusionmay
needtoberepositioneddepending
onyourapplication.Forexample,in
stairrailapplications,thecentering
extrusionmayneedtoberaisedto
allowattachmentofthestairbrack-
ets.
Note:
Insomecases,thevinylsleevewill
needtobenotchedtoextendbelow
theplaneofthestandingsurface
tohidetheposttailandmounting
hardware(Fig.13).*Endurancerail
kitsmeasure34”or40”fromthe
bottomofthebottomrailtothetop
ofthetoprail.
(Fig. 12)
(Fig. 10)
(Fig. 11)
6.5"Minimum
34"or40"*