Installation Guide

3
ENGLISH
2.
Establish the height of the lower rail using
blocks for the desired bottom space.
Place the bottom rail across the opening
where it is to be installed (Fig. 1).
Tip: Standard Original Rail measures 36" in
height with a 2" space below the bottom rail.
Use 2" blocks to establish bottom rail height.
1.
Prepare all posts and mounting surfaces
before installation.
3.
Measure from the mounting surface to the
rst baluster hole on each end (Fig. 2) and
adjust until these dimensions are equal.
Trace the post onto the bottom rail and mark
1/8" short at each end to allow for expansion
(Fig. 3).
Tip: If all of your mounting surfaces are
plumb, transfer your measurements and
baluster layout from the bottom rail to the top
rail (Fig. 4).
NOTE: A minimum of 1¼" from the edge of the
rst baluster to the end of the rail is necessary
to accommodate the mounting brackets.
(Fig. 1)
(Fig. 3)
(Fig. 2)
(Fig. 4)