Instructions / Assembly

14
(Fig. 28)
(Fig. 30)
(Fig. 29)
14.
Pre-drill downward using a 1/8" drill bit.
Be sure to drill through the beam and
bracket (Fig. 27).
If needed, an additional rail stiffener
(N) can be purchased separately, and
installed in place in top rail (A) as shown
below.
Cut the top rail (A) to length at the stair
angle (Fig. 28).
15.
Snap the top rail (A) onto the top beam
(D) by applying downward pressure.
Work from the bottom of the stair to the
top end of the rail until the full length of
the cover locks into place (Fig. 29 & Fig.
30).
If using stiffener,
insert into top of
top rail as shown.
Stiffener shape will
vary based on top
rail pro le.
(Fig. 25)
(Fig. 26)
13.
Set the top beam (D) in place by
inserting the  rst baluster plug (at the
bottom post) in the corresponding
baluster, setting it in place, and working
towards the top (Fig. 25).
Position the beam between posts to
ensure proper alignment. Pre-drill the
post for the center bracket screw using
a 1/8" drill bit. Secure the brackets to
the post using 3 mounting screws (G) in
each bracket, beginning with the center
screw hole (Fig. 26).
(Fig. 27)