Installation Guide

10
ENGLISH
LED UNDER-RAIL LIGHTING INSTALLATION
Crossover Product transformer, harnesses, and splitters are compatible with all Crossover Product lighted accessories (post caps, side/stair
lights, dome lights, under-rail lighting, and ush-deck lights) and Transform lighted accessories (Transform post caps, Transform dome lights).
NOTE: Under-Rail Lighting should be installed prior to the completion of your railing installation for the most seamless install as you
will be required to drill through the posts where the top rail meets the post.
Under-Rail lighting can be installed directly
on the underside of your top rail or by
using the PVC under-rail light channel (sold
separately).
Under-Rail light strip comes with an
adhesive backing for easy install as well as
a secondary adhesive strip for the under-rail
light channel. The Under-Rail light strip has a
connector at one end of the strip to plug into
the harness running up your post.
1.
Mark on your posts using a pencil where
the under-rail light strip will connect to the
harness (running up inside the post) and
exit the post sleeve to the top rail of your
railing section. This hole will be hidden once
the brackets and top rail are mounted to
the post. Drill a ½" hole in the post at this
location (Fig. 1).
If your top rail has visible brackets, make a
mark on the underside of the top rail where
the bracket is located. Drill ½" hole in top rail
at this mark (Fig. 2), moving brackets aside
if necessary. This is where the light strip will
exit the top rail and run along the underside
of the top rail.
2.
Measure the length along the top rail that
the under-rail lighting strip will run. This may
be post-to-post if your brackets are hidden,
or bracket-to-bracket if the brackets are
exposed (Fig. 3). If using the under-rail light
channel, subtract ¼" and cut the channel
to this length using a ne-toothed saw. Cut
under-rail light strip to the required length.
NOTE: under-rail light strip can only be cut
at the designated locations (located every 2"
along light strip) as shown in gure 4.
(Fig. 2) (Fig. 4)
(Fig. 1)
MEASURE
(Fig. 3