Installation Guide
6
ENGLISH
LED POST CAP INSTALLATION
Crossover Product transformer, harnesses, and splitters are compatible with all Crossover Product lighted accessories (post caps, side/stair
lights, dome lights, under-rail lighting, and ush-deck lights) and Transform lighted accessories (Transform post caps, Transform dome lights).
1.
Plug the male connector that is at the top of
your post (Fig. 1) into the female connector
attached to the light. Press rmly until the
connection is fully engaged.
Connection is fully engaged when there is
minimal gap between the male and female
connector. Ensure all excess wiring is
concealed in the post and will not interfere
with the post cap tting on the post or post
sleeve.
For vinyl post caps, a reector plate is
included; place this on the top of the wooden
4" x 4" or structural post to deect the light
upward.
2.
Carefully align the post cap light and set on
top of the post or post sleeve (Fig. 2). Any
extra wire can be coiled up inside the post.
Plug the female harness connector at
the base (Fig. 3) of the post into the male
harness connector on the transformer. The
post cap light will now be illuminated if the
transformer is on.
3.
(Optional) After the light is conrmed working,
lift the post cap light from the post and apply
a bead of clear exterior silicone caulking (not
supplied) where the post cap light will be
installed onto the post or post sleeve (Fig. 4).
Place post cap light onto the adhesive.
(Fig. 1) (Fig. 3) (Fig. 4)
(Fig. 2)