Specifications

EC9100i and EC9600i Series Scanner User Guide Setting up your scanner
©2016 RDM Corporation Page 19
Connecting the power cord
1. Align the flat side of the power connector so that it is facing up.
2. Insert the round end of the power cord into the power port on the back of the scanner.
When the cord is pushed in completely, it clicks into place.
3. With the power cord connected to the power adapter, plug the other end of cord into an
electrical outlet.
4. If your power cord has an on/off switch, make sure the switch is in the “on” position.
Disconnecting the power cord
Caution: Disconnecting the scanner from a power source while the scanner is processing a transaction
might cause data loss.
The power cord has a sleeve on it that secures it to the unit. The security sleeve prevents the power
cord from being pulled out of the unit accidently.
1. Hold the unit in place with one hand to prevent the unit from falling.
2. With your other hand, slide the power cord security sleeve back and pull the power cord free of
the scanner.
Installing cartridges and paper roll
For installing the franker cartridge, see Replacing the franker cartridge on page 29.
For installing the endorser inkjet cartridge, see Replacing the endorser inkjet cartridge on page 29.
For installing the paper roll, see Replacing the paper roll for the printer on page 31.
Drivers and applications
There are many applications that support the RDM EC9100i and EC9600i scanners. Most are available
from third-party vendors. If you are not sure where to acquire your check scanning application, check
with whoever provided your scanner.
The drivers for RDM EC9100i series scanners are installed on your computer when you install your check
scanning application.