Specifications

Table Of Contents

EC9100i and EC9600i Series Scanner User Guide Setting up your scanner

EC9600i scanning application requirements

The EC9600i series network scanners do not require that you install any drivers on your computer.

However, depending on your scanning application, there might be some additional setup required for

the application to connect to the scanner. For example, you might need to:

• Install a security certificate on your computer.

• Make changes to your browser’s security settings.

• Configure or select your scanner in the scanning application.

For more information about EC9600i setup requirements, see your scanning application’s

documentation.

Connecting the EC9600i network scanner

The EC9600i network scanner can connect to your computer via a USB cable or over the network. There

are three ways to hook up the scanner:

• Scanner and computer have separate connections to the network.

• Computer is connected to the network through the scanner. (EC9603f, EC9604f, EC9607f, and

EC9608f only.)

• Scanner is connected to the computer using USB.

Option 1: Scanner and computer have separate connections to the network

In this setup, you connect the scanner to the network. Your computer retains whatever network

connection it had previously.

Considerations:

• All workstations on the same network can connect to the scanner.

• Requires a dedicated Ethernet connection for the scanner.

• Can be used by both auto-feed and single-feed network scanners.

To hook up:

1. Plug an Ethernet cable into one of the Ethernet ports on the back of the scanner (marked in red

below).