Installation Guide

REACH Barrier LLC. 860 N. Dorothy Dr., Suite 608 - Richardson, TX 75081 - 972-331-3933
www.reachbarrier.com - [e-mail]
REACH Barrier – Garage Door Insulation Kit Install Instructions:
Practice/Step 1: It is best to use the extra size of
the panel to help hold the panel in place. Simply
“push” and “move” the panel in the proper position
within the panel to the desired fit (before using
the Stick’ems™ adhesive squares!) Once you
“see” how the panels will fit proceed to the next
step.
Step 2: Peel off backing of a Stick’ems™ and
stick one (1) in each of the four corners of the
garage door panel and one (1) or two (2) in the
center as shown. Once the Stick’ems™ have
been stuck to the door peel off the top layer of
paper to reveal the other sticky surface below.
Step 3: Once you have the Stick’ems™ in place
and removed the paper to reveal the sticky
surface, the radiant barrier panels can be pushed
into place.
Finish: Stick’ems™ require 24 hours to become
fully stuck.
Begin by cleaning the surface of the
inside door panels where the adhesive
squares (Stick’ems™) will be used to
hold the radiant barrier panels in
place.
NOTE: There are eight (8) radiant barrier
panels in the kit. Each panel is 4 feet in length.
It is recommended that you use (5-6)
Stick’ems™ per panel. 48 squares are included
in your kit to complete the installation.
For improved thermal performance, add 3/4” air space
between Reflective Air and door. This can be done by
attaching to door framing rather than to the door panel
Kit # 3009
NOTE: There is no “right side” to the panels
– Just pick the side you wish to look at