Installation Guide

BACK TO
NATURE
HI-SPEED READY-STRIP
®
CITRUS PAINT & VARNISH REMOVER
TECHNICAL DATA SHEET
I. Description: Finally, a faster safer stripper
capable of removing paint or varnish as quickly as a
½ hour. It can remove up to 3 layers in a single
application. This water based paint remover is
environmentally friendly, non-flammable, has a low
odor, and does not contain harsh chemicals such as
methylene chloride or caustics.
II. Types of Paint Removed: Hi-Speed Ready-
Strip® will remove most varieties of household
paints including oil and water based paints,
varnishes, latex, stains, enamels, lacquers, and
polyurethanes.
III. Surfaces: Hi-Speed Ready-Strip® works on
most surfaces including wood, plaster, metal,
masonry, concrete and fiberglass. It is NOT to be
used on sheetrock, plastic, rubber or linoleum
surfaces.
IV. Instructions:
A. TEST PATCH - Since it is often hard to
know the type or amount of paint or varnish on a
surface, a small test area should be tested first to
determine whether the desired results will be
achieved.
B. Preparation- Mask any areas not being
stripped with plastic and masking tape.
C. Application and Removal:
Pour Hi-Speed Ready-Strip® into a tray and apply
liberally by brush, putty knife, medium nap paint
roller, or airless sprayer. Apply at temperatures
between 60
0
F and 80
0
F. Leave Hi-Speed Ready-
Strip® on approximately ½ hour to 1 hour. Leave the
stripper on longer for multiple layers. You may
notice blistering or what appears to be no reaction at
all. Use a paint scraper to lift paint from flat surfaces
or a stiff bristle brush for detailed areas. After initial
lifting, use a nylon brush or stripping pad with
Ready-Strip® Wash or light amounts of water for
final clean-up of residue. If you are not down to the
original surface, re-apply. Let surface thoroughly dry
before re-finishing. No need to neutralize (acid
wash) surface. Clean tools promptly after use with
soap and water.
D. Coverage: A half-gallon covers
approximately 50-60 square feet. A pint covers
approximately 15 square feet.
V. Safety and First Aid Instructions: Rubber
gloves and safety glasses are recommended for eye
and skin protection. Avoid eye contact. If eye
contact occurs, immediately flush with plenty of
water for 15 minutes. Avoid prolonged and repeated
contact with skin. If skin contact occurs, wash with
soap and water. If spraying is expected use NIOSH
approved chemical cartridge respirator. If swallowed
do not induce vomiting. Give 1 or 2 glasses of water
and call physician immediately.
SUNNYSIDE CORPORATION 225 CARPENTER AVENUE WHEELING, IL 60090-6095 PH:847-541-5700 FAX: [phone]