User Manual

ReadyLift
®
(Part# 66-5251) Strut Extension, Installation Instructions
2012-2014Toyota Tundra 4WD 3” Lift
ReadyLift Suspension Inc.
Toll Free [phone]
Remove the skid plate. Some
models may have two skid plates.
A 12mm socket is needed.
Using a 22mm socket, loosen and remove
the lower strut mounting nut and bolt from
lower control arm.
Starting on the driver side, remove the five lug nuts and the wheel.
Using a 24mm socket, loosen but don’t
remove the driver side lower control arm
bolts. This will allow the lower control arm
to move freely.
DO NOT REMOVE ALIGNMENT CAMS.
Using a 19mm socket, loosen and remove the sway bar end link bolt
on the lower control arm.
Front control arm bolt
Rear control arm nut
6.
5.
4.
3.
2.
Rear control arm nut
Lower strut mounting nut
1.
Position truck on a flat surface and lift vehicle by the frame so that the front wheels are off the ground. Use
a floor jack and jack stands or a two post lift if available.
Please read instructions thoroughly and completely before beginning installation.
Check www.readylift.com for any updated installation instructions.
Installation by a trained mechanic is recommended.
Prior to lifting the vehicle, measure the stock height so that you
have a base line to check after the kit has been installed. Meas-
uring the vehicle from the bottom of the wheel to the lip of the
fender is recommended.
Lower strut mounting bolt