Manualshelf

User Manual

ManualsBrandsReadylift ManualsAutomotiveReadyLift 69-2535 3.5'' SST Lift Kit with 5'' Rear Tapered Blocks - 1 Piece Drive Shaft without Shocks
123456789
www.ReadyLIFT.com
Phone (702)410-2300
Installation Steps (69-2011, 2511, 2511TP, 2531, 2535, 2537, 2538)
Shown dr. side new 3/8 brake line hole location. (11-up) models replace OE bracket with new drop bracket.
Loosen hard line ferrule rotate block 180 degrees and tighten Note line direction, replace OE bracket with new drop bracket
Reinstall block into bracket with retaining clip. Support front axle with floor jack(s).
Note: differential vent line and ABS brake lines. (05-10) disconnect dr/pass lower front sway bar endlink bolt.
OE holes
New 3/8 hole
Vent line
ABS line
Remove clip