User Manual

Note: Final torque of the new U-bolts should
be done with the vehicle on the ground and
to the proper specs. Make sure the u-bolts
have the equal amount of threads visible on
all (8). Take care to tighten the carrier drop
plate centered and aligned on the cross-
member. Recheck all work before and after
test drive.
www.ReadyLIFT.com
Phone [phone]
Installation Steps (69-2011, 2511, 2511TP, 2531, 2535, 2537, 2538)
Raise Vehicle and support by frame. Support axle with jack. Vehicles with ABS/TC remove clips from U-bolts.
Remove U-bolt nuts and axle mounting plate.
Remove U-bolts and slowly lower axle to remove OE block.
Lower axle enough to install taller block, align and raise axle .Install longer U-bolts and nuts onto axle plate. Torque later.
With vehicle on the ground install carrier bearing drop plate.
Optional: If necessary