Instruction Manual

Then reconnect lower shock bolt and tighten the
upper shock mounting bracket. Reinstall wheels/
tires, lower to ground and torque. Reconnect
lower sway bar endlinks and test drive. Recheck
all work performed and have vehicle aligned.
www.ReadyLIFT.com
Phone [phone]
Installation Instructions (66-1090 & T6-1090)
Next, remove upper rubber spring isolator. Then remove shock tower nuts and retaining plate.
Note: This step shows T6 Billet only spacer assembly. Install spring spacer over shock and into factory position.
Install spring spacer into frame pocket w/provided hardware. Reinstall OE rubber spring isolator onto spacer.
Reinstall spring back into position and raise axle.