Manual

www.ReadyLIFT.com
Phone [phone]
Installation Instructions (66-3111, 66-3112)
Raise and support vehicle on level ground and support frame. Release ABS clip from bracket on axle.
Support axle and remove U-bolt hardware and axle bracket Remove U-bolts and lower axle to allow lift block positioning
Note slight taper on block, shorter end towards front of truck Raise axle aligning center pin and install new U-bolts/nuts.
Slide ABS wire clip at frame up to gain slack to avoid damage Torque U-bolts with vehicle on ground and re-clip ABS wire