66-5001 & 66-5002 2005-UP Toyota Tacoma 2/4WD 6-Lug, 2000-UP Toyota Tundra 2/4WD Installation Instructions www.ReadyLIFT.
66-5001 & 66-5002 2005-UP Toyota Tacoma 2/4WD 6-Lug, 2000-UP Toyota Tundra 2/4WD Installation Instructions Torque Specs in FT/LB Bolt Size Millimeters Metric Grade 8.8 Metric Grade 10.9 6mm 6 8 8mm 16 22 10mm 40 45 12mm 54 70 14mm 89 117 16mm 132 175 18mm 182 236 Description 66-5002 pictured Parts List Qty 66-5001 1” tall cast steel lift block M14-1.5 X 210mm U-bolts M14-1.5 serrated flange nuts 2 4 8 66-5002 2” tall cast steel lift block M14-1.5 X 235mm U-bolts M14-1.
66-5001 & 66-5002 2005-UP Toyota Tacoma 2/4WD 6-Lug, 2000-UP Toyota Tundra 2/4WD Installation Instructions Please read Instructions thoroughly and completely before beginning installation. Installation by a certified mechanic is recommended. ReadyLIFT Suspension Inc. is NOT responsible for any damage or failure resulting from improper installation.
Installation Instructions (66-5001 & 66-5002) **TUNDRA notes** Raise vehicle securely by frame and support axle with jack.. Work on one side at a time to prevent driveline damage. Disconnect ABS wiring brackets from axle. Remove rear lower shock bolt and disconnect shock. Remove u-bolt nuts and lower plate. Carefully lower axle and remove u-bolts Place new lift block into position between axle and leaf pack. Raise axle and ensure locating pins are properly aligned. www.ReadyLIFT.
Installation Instructions (66-5001 & 66-5002) **TUNDRA notes** Slide new u-bolts over leaf pack and bumpstop bracket. Attech lower mounting plate with provided hardware. Replace shock on mount and ABS line to axle. Repeat steps on opposite side and torque when completed. **TUNDRA ONLY using 66-5002, follow these steps.** Remove brake line bracket bolt from axle tab. Axle tabs and brackets are different on either side. Install provided brackets with OE and provided hardware. 66-5002 pictured www.
6-5001 & 66-5002 2005-UP Toyota Tacoma 2/4WD 6-Lug, 2000-UP Toyota Tundra 2/4WD Installation Instructions Final Checks & Adjustments Post Installation Warnings: Once the vehicle is lowered to the ground, check all parts which have rubber or urethane components to insure proper torque. Torque wheels to factory specs. Move vehicle backwards and forwards a short distance to allow suspension components to adjust.
