User's Guide

ManualsBrandsReadyNet ManualsComputers & AccessoriesWireless Router

Setting Up Your Wireless Devices

our wireless devices (desktop, laptop, iPad, smart-phone,

etc.) must be conﬁgured to work with your wireless router.

Each of these devices must have an internal or external

wireless adapter and applicable drivers. User guides for

each of these devices should have instructions for wireless

set up. You will need the SSID and password you assigned

to this wireless router during router setup. For each wireless

device, access the setup menu, choose the appropriate

SSID from the list of wireless networks, enter your

password, and test the wireless connection.

Quick Inst

allation Guide

Your LTE500 has been pre-conﬁgured with an SSID

(wireless network name) and security pass phrase.

See the sticker on the bottom of your router for this

information. If you wish to change these or other

settings, use the following instructions.

Figure 4

300Mbps

Wireless Router

www.readynetsolutions.com

FCC Statement

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one

or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject

to the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth

for an uncontrolled environment.

This transmitter must not be coÿlocated or operating in conjunction

with any other antenna or transmitter.

This equipment should be installed and operated with minimum distance

20cm between the radiator& your body.

Caution

Any changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate

the equipment.

Summary of content (2 pages)

PAGE 1
D. Setting Up Your Wireless Devices Your wireless devices (desktop, laptop, iPad, smart-phone, etc.) must be configured to work with your wireless router. Each of these devices must have an internal or external wireless adapter and applicable drivers. User guides for each of these devices should have instructions for wireless set up. You will need the SSID and password you assigned to this wireless router during router setup.
PAGE 2
A. Connect the LTE500 Router to Your Computer 1. To set up your router for the first time, please connect the router to your desktop or laptop computer as shown in the following diagram. Your broadband Internet access will generally be from a service provider modem such as a cablemodem, ADSL modem, or similar device. 2. After the hardware connections have beencompleted, check the status of the LED Indicators using the following table: LED Indicator POWER Mode or USB 2.4G Wi-Fi WAN LAN 1-4 B.