Instructions / Assembly

REMOTE CONTROL OPERATION
To use the remote control, make sure that the Power Switch (I/O) on the fireplace has
been turned on.
13
OPERATION AND FEATURES (Cont’d.)
POWER (STANDBY)
This will turn the unit ON/
OFF in standby mode.
ADJUST BRIGHTNESS
This allows you to raise or
lower the level of flame
brightness.
FLAME COLOR
This button changes the
color of the flame.
HEAT SETTING
Press this button once for
the low heat setting (700W);
press twice for the high heat
setting (1400W); press again
to turn o the heater.
REMOTE CONTROL BATTERY REPLACEMENT
The remote control requires one 3V CR2025 Lithium Cell Battery (included).
Remove the protective sheet between the battery and the contacts in order to
operate. See Fig. L.
Fig. L