Use and Care Manual

Ambient Light
This will turn the ambient light
above the logs ON/OFF.
OPERATION AND FEATURES
Using the Remote Control
Adjust Brightness
This allows you to raise or
lower the level of ame
brightness.
Adjust Temperature
This allows programming of
the thermostat. The rebox
can be used without the
heater if desired, simply cycle
through the function until
no temperature is displayed.
Press and hold the down
arrow for ve seconds to
switch temperature readout
from °F to °C and back.
Timed Shut-O
This allows you to set the
replace to automatically
shut OFF after the amount
of time displayed on the
screen. Timer can be set
for ten minutes up to nine
hours.
Dynamic Embers
This function will make the
embers of the re automatically
glow dimmer and brighter
creating a realistic re eect.
Timer/Dynamic Embers
This will allow you to set
the automatic shuto
on the replace. Hold
for 5 seconds to switch
to Dynamic Embers.
This function will make
the embers of the re
automatically glow
dimmer or brighter
creating a realistic re
eect. Hold 5 seconds
to return to Timer.
Power
This will turn the unit ON/
OFF. When turned back
ON, the system will recall
its last heat setting used.
Power
This will turn the
unit ON/OFF. When
turned back ON, the
system will recall
its last heat setting
used.
Adjust Brightness
This function will
cycle through the
ve dierent levels of
ame brightness.
Adjust Heater
This function will
cycle through the
dierent temperature
levels of the heater.
Hold 5 seconds
to switch readout
between °F and °C.
Ambient Light
This will turn the
ambient light above
the logs ON/OFF.
Using the Control Panel
6