Installation Guide

7
This rebox is equipped with power saving programs. In order for the remote to
become active, the power must rst be turned ON manually by using the Control Panel. If the
power is turned OFF manually with the Unit Control Panel or with the automatic timer mode, the
remote cannot be used to turn the rebox ON. If the remote does not seem to function, turn the
unit ON using the control panel to engage the remote.
When turned OFF the embers of the log set will not immediately go out. This is a
designed feature to represent the embers of the re slowly fading out.
Although the heater has been turned o the fan may still run to prevent over heating.
OPERATION AND FEATURES
Digital Display
!
!
!
NOTE
NOTE
NOTE
Timer Function
This icon will light up
with a blue light when
using the Timed Shut-
OFF function. A time will
be displayed on the main
display ranging from 10
(minutes) to 9H (hours).
Flame Brightness
When adjusting the
brightness of the ames
this icon will light up with
a blue light. The setting
will be displayed on the
main display with 1 being
the lowest setting and 5
being the highest.
Main Display
All numerical information
will be displayed on this
screen along with the
related function icon.
Thermostat
°F or °C will be
displayed along with
the temperature on
the main display. The
rebox can be used
without the heater if
desired, simply cycle
through the function
until no temperature
is displayed. For
instruction on
switching between °F
and °C please refer to
page 8.
˚F
˚C
Approved for use in the
United States and Canada