Specifications Sheet

PRE-USE INSTRUCTIONS
Prior to each gas fire bowl operation, check the hose and valve for evidence of excessive
abrasion or wear.
CHECKING FOR LEAKS
BURNER CONNECTIONS
Make sure the regulator valve and hose connections are securely fastened to the burner and the
tank. If your unit was assembled for you, visually check the connection between the burner pipe
and orifice. Make sure the burner pipe fits over the orifice.
Warning Failure to inspect this connection or follow these instructions could cause a fire or
an explosion, which can cause death, serious bodily injury, or damage to property.
Please refer to diagram for proper installation.
If the burner pipe does not rest flush to the orifice please
contact Real Flame at 1-800-654-1704 for assistance.
Ma
Make a leak check solution by mixing 1 part dishwashing
soap with 3 parts water in a spray bottle.
ke sure control knob is “OFF.” Then, turn LP gas tank
to “ON” at valve.
Spray leak solution on valve connections paying particular
attention to the areas indicated by arrows.
If any bubbles appear turn LP gas tank OFF, reconnect and
retest. If you continue to see bubbles after
several attempts, disconnect LP gas source and
contact Real Flame at 1-800-654-1704 for assistance.
If no bubbles appear after one minute turn tank OFF, wipe
away solution and proceed.
!
Check for leaks at these locations
WARNING Before using this outdoor fire bowl, make sure you have read, understand and
are following all information provided in the important Safety Information section of this
manual. Failure to follow those instructions can cause death, serious injury or property damage.
!
!
11