Specifications Sheet

8
ASSEMBLY INSTRUCTIONS
1.) Place lava rock by hand. Do NOT dump bag out into tray to avoid clogging the
burner with dust. First, position the lava rock inside and around the burner as shown.
Next place the lava rock around the perimeter of the fire bowl and make sure that you
do not block the igniter housing with lava rock to ensure proper ignition.
2.) Install the battery in the igniter.
Igniter Housing
Lava Rock and Glass Filler Warning:
Do not light or use this fire bowl if filler is wet. Ensure filler is completely dry before lighting.
Intense heat can cause wet filler to explode and hit someone causing injury.
Please keep away from the fire bowl for at least 20 minutes during initial startup as filler
could retain some moisture from manufacturing and shipping.
Do not overfill the burner area with rock or glass filler. The depth of the filler should not be
more than one inch above the burner tube. Only Real Flame filler products have been
certified and tested by CSA for safe use with this Real Flame fire table. Using other filler
material may result in increased popping and cracking or increased CO gas emission.
2.
3.
1.